Adding sound to a LGB 20261's powered tender

zach2thefuture

zach2thefuture

Registered
I have a LGB 20261 and I want to add a sound unit to it. I expect that it would be easiest to add it to the tender, but I can't find much information on taking one apart. Is this the best way to go about it?1000035211.jpg


Sorry if this is a very simple question, I haven't had much experience with garden railroading since I was a child, and apparently a lot has changed in the last 30 years!
 
There is certainly more space in the tender, but probably not as much as you think..

Just four screws, to separate top and bottom, normally.

PhilP
 
zach2thefuture said:
Would I be better off adding a sound module to a car instead of the tender?
Click to expand...
Is your tender powered?
If you already have pickups, then that makes some of it a little easier, though you can always use the socket on the rear of the Stainz, to give you power.

Do you just want a 'chuff' or are you after more than this?

PhilP
 
With a bit of creative placement, you can fit a fair amount in one of the powered tenders.

Mine has:

Loksound V5 XL
ESP32 WiDCC Receiver
WiDCC board + Cytron MD13S
13200uF cap bank
Visaton 50mm speaker
DCC distribution board + selector switch
Servo for the rear coupler

CrIWbt2l.jpg


E2T1XpBl.jpg


I also took the gearbox apart to add a magnet ring and hall effect sensor for chuffs:

KviyDeEl.jpg


uHwAmV9l.jpg
 
Cobalt6700 said:
With a bit of creative placement, you can fit a fair amount in one of the powered tenders.

Mine has:

Loksound V5 XL
ESP32 WiDCC Receiver
WiDCC board + Cytron MD13S
13200uF cap bank
Visaton 50mm speaker
DCC distribution board + selector switch
Servo for the rear coupler

CrIWbt2l.jpg


E2T1XpBl.jpg


I also took the gearbox apart to add a magnet ring and hall effect sensor for chuffs:

KviyDeEl.jpg


uHwAmV9l.jpg
Click to expand...
That's a hell of a job, maybe I'll be there one day!
 
You must log in or register to reply here.
Back
Top