electricity_bill
Registered
Hello
Can anyone please tell me the minimum radius for a Bachmann K27 loco?
Bill
Can anyone please tell me the minimum radius for a Bachmann K27 loco?
Bill
Bachmann K27
- Thread starter electricity_bill
- Start date
funandtrains
Registered
Re:Bachmann K27
Although you will find that the overhangs are very large. I had to relay my R3 / 8 foot diameter loop as the cab hit quite a few objects and wouldn't fit through the gaps in 2 places.
Richie said:
Although you will find that the overhangs are very large. I had to relay my R3 / 8 foot diameter loop as the cab hit quite a few objects and wouldn't fit through the gaps in 2 places.
Re:Bachmann K27
Am the lucky owner of a k 27 as wel
before the conversion of my railroad It was running on R3 curves, basically no problem, but
on the switches the front weel can derail when driving to fast. and when that happens the plastic construction of the front wheel will
break, had to learn this the hard way so my personal advise would be to use r5 curves 10ft if i am correct.
In this case you can walk to the fridge in your lgb shack to get your no 1 beverage without having to worry that your loco derails
I find the k27 a verry nice loco runs great and can haul enormous loads,
I fixed the front wheel construction with a messing piece and replaced the original wheel with a stainless wheel with a litle bit higher flanges.
and now it runs perfect.
brgds niels
Am the lucky owner of a k 27 as wel
before the conversion of my railroad It was running on R3 curves, basically no problem, but
on the switches the front weel can derail when driving to fast. and when that happens the plastic construction of the front wheel will
break, had to learn this the hard way so my personal advise would be to use r5 curves 10ft if i am correct.
In this case you can walk to the fridge in your lgb shack to get your no 1 beverage without having to worry that your loco derails
I find the k27 a verry nice loco runs great and can haul enormous loads,
I fixed the front wheel construction with a messing piece and replaced the original wheel with a stainless wheel with a litle bit higher flanges.
and now it runs perfect.
brgds niels