Suppliers list

[craigrailinc]

Can somebody tell me where the suppliers list is please.
I need a LGB 65003 diesel sound unit repaired and also a LGB 2-4-0 22232 which was running fine but stopped as there doesn't appear to be power from the wheels getting to the motor.
which when I have it apart and apply power to the tabs on the motor runs fine but when I apply power to the pick ups nothing. any help and ideas would be good

 

[Neil Robinson]

LGB 2-4-0 22232 which was running fine but stopped as there doesn't appear to be power from the wheels getting to the motor.
which when I have it apart and apply power to the tabs on the motor runs fine but when I apply power to the pick ups nothing. any help and ideas would be good

My guess is a problem on the circuit board.


One way to check is to unplug the motor block from the board and see if it'll run it on its own.
You'll need to link the first of the four wires from the motor block to the second and also link the third to the fourth.
To do this I often use two U shaped pieces of fairly thin bare wire pushed into the socket that normally plugs into the circuit board.
If it runs it means an open circuit on the circuit board, if not then the open circuit is in the motor block.

If the problem's with the board I recommend checking that the motor isn't taking excessive current. On its own and clear of the rails the motor block should take around 0.3A. When removed from the block the motor should take around half of that.

Edit, then again the four way switch may have been accidentally moved, it's worth checking before taking everything apart.