Thirdrail68
Registered
Hi,
Im looking for some advice. My bus wires are 10awg. My NCE 10amp DCC system has small wire connectors and the 10 gauge wires are too thick to fit in.
The only way i can think this will work is if i connect the 10 awg wires to screw terminals and then connect smaller wires from the screw terminal to the NCE connector. By doing this though will i loose power going from 10 awg to say 16 awg.
Can anyone advise please
Steve
Im looking for some advice. My bus wires are 10awg. My NCE 10amp DCC system has small wire connectors and the 10 gauge wires are too thick to fit in.
The only way i can think this will work is if i connect the 10 awg wires to screw terminals and then connect smaller wires from the screw terminal to the NCE connector. By doing this though will i loose power going from 10 awg to say 16 awg.
Can anyone advise please
Steve