LGB 55021 problem after 55 reset

M

MaidaVale

Registered
Country flag
I have done a reset on a LGB 55021 using the hand held programmer 55015. I did P 6 55 > then P5 55> and now I have nothing. If I remove the card and turn the dip switched on the loco drives fine in DC on the main board. Am I missing something, have done something wrong, is there a default CV that needs to be programmed after a reset?

Thanks Kym
 
Have you put your loco address back in the chip, or tried it on address 03....
 
You must log in or register to reply here.
Back
Top