My winter project LGB Dampfschneeschleuder Xrot RhB
- Thread starter Philbahn
- Start date
Can anyone recommend a motor I can use for the blower. I have tried a 600 and 550 from the model shop but they are only 3 pole and are reluctant to start, Also they are only rated at 7.5 volt.
Ok I could buy a drill motor at about £40.00 but I am looking for something cheaper.
Have you got one spare??????????????? Idealy 5 or 7 pole 12 / 24 volt
Ok I could buy a drill motor at about £40.00 but I am looking for something cheaper.
Have you got one spare??????????????? Idealy 5 or 7 pole 12 / 24 volt
Philbahn said:
Hi Phil
I have 1/2 a dozen re-chargeable drills, all with dud batteries, cheaper to buy new drill than a new battery.
You are welcome to one for the P&P, but you will have to excuse my lack off knowledge
can get the voltage of the batteries, but how can i tell if they are 5 or 7 pole??
Happy to strip a few down if thats the only way
Rob
annieshalt
garden railways
better hurry up phil, the snow is here already.:wits:
Philbahn said:annieshalt said:
I know, Allan. It's Rob holding me up,.
:impatient: :timeout: :timeout: Now i think thats a stretching the facts a bit,
especially after me spending 25Mins hanging over the side of our scrap bin
this morning (5.30am), it was BL@@Dy cold as well. :crying:
Think a good modeler would anticipate his needs and
collect all the bits in advance
Managed to find a few cast off's though
Hope the one below is OK, 18volts, but still don't know how to tell how many
poles it has,
It was a very powerful drill at the time, would knock 50 10mm dia holes 50mm
deep in to Brickwork in an hour & half, batteries lasted 18months before they
stopped holding a charge.
Any ways up, :wave:
After all the cheek, not sure how much time it will take to dismantle
then there's a box to be found
and sellotape
and scissors
and a trip to the post office,
and if it snows, well would it be sensible to venture the 2miles down the rd
Any one want to start a 'Pole' on all the above plus Parcel forces delivery time
at x-mass.
[attachment deleted by admin]
Any ways up, :wave:
After all the cheek, not sure how much time it will take to dismantle
then there's a box to be found
and sellotape
and scissors
and a trip to the post office,
and if it snows, well would it be sensible to venture the 2miles down the rd
Any one want to start a 'Pole' on all the above plus Parcel forces delivery time
at x-mass.
[/quote]
Rob it was just a jibe:holdon:
I would say a big Thank you[size=16pt] for your efforts
I got two motors but they are not right for the purpose
If you want just send the complete drill less battery
Also don;t forget to pm me with the cost:thinking:
[/size]
After all the cheek, not sure how much time it will take to dismantle
then there's a box to be found
and sellotape
and scissors
and a trip to the post office,
and if it snows, well would it be sensible to venture the 2miles down the rd
Any one want to start a 'Pole' on all the above plus Parcel forces delivery time
at x-mass.
[/quote]
Rob it was just a jibe:holdon:
I would say a big Thank you[size=16pt] for your efforts
I got two motors but they are not right for the purpose
If you want just send the complete drill less battery
Also don;t forget to pm me with the cost
:thinking:[/size]
Steve said:
May well take you up on the offer steve, :callme: you still up for your usual 50% of the profit this drill cost me £25 new
That weather forcast is looking very snowish to me. :thinking:
Typical Last night he only wanted the motor, now he want's the whole drill
after me spending many minutes taking it apart :brokeheart:
and seems he is getting a bit tetchy too,
I know it was only a bit of fun
,but honestly some people
and now it seems he has gone to :sleep: :sleep:
When i could of been playing with me new [strike]toy[/strike] model Loco
Slight thread drift any body got any good tips for using one of these
on analogue